Digital sentry safe4/9/2023 ![]() Comes ON after you enter a valid code/passcode and remains lit during the 4-second period in which the safe can be opened.After entering each digit of Factory or User Code, or Passcode.You have let 5 seconds or more elapse between key entries. ![]() You have entered an invalid code or passcode.You have pressed Program key out of sequence.Red (Error) LED + three beeps indicates one of the following: ![]() Your electronic-lock safe communicates by means of several audio/visual signals. Unlock the door by inserting the key provided into the hole and turning clockwise. Remove the keypad by rotating the cover counterclockwise, then pull toward you. If your electronic lock fails or you do not have any codes available, you may use a key override to access this unit. (If you realize you have made an error while entering your code, press the CLEAR button and start over.) Key override If you fail to do so in time, the lock will reactivate. Once you have done this, you have 4 seconds to open the safe by turning the handle or 4-bitted key to the unlock position. To unlock the safe, you must enter a valid Factory Code, User Code or Passcode. To erase the passcode, press Program twice, enter your User Code and then enter 00000.) Unlocking (To enter a new passcode, repeat these steps. Enter the 5-digit passcode of your choice (any combination except 00000.) After 5 digits are entered, the green LED turns OFF.(To enter a new User Code, repeat these steps.) Programming a passcode The lock will “beep” and the green LED will come on. (To enter a new User Code, repeat these steps.) After 5 digits are entered the green LED turns OFF. The green LED remains ON while you enter the 5-digit user code of your choice. There are two ways to program a user code. If you wish to give someone else temporary access to the safe, you can program a passcode that can later be erased. But if you prefer to use your own code, you can program the safe to open to the 5-digit User Code of your choice. You can always open the safe by entering the 5-digit Factory Code. There are three possible ways to unlock and access the safe-by entering its preset Factory Code, your own User Code or a Passcode. If you pause longer, an error signal will occur (blinking red light and three beeps), indicating you should start over. The lock allows 5 seconds for each key press. A green PROCEED light and a single beep indicate that the keypad “felt” your touch. For units with key, turn the key to the right.(Be sure key lock is turned as far left as possible.) Insert the four-bitted key into the lock to the left of the key pad.Some electronic units are equipped with a handle OR electronic lock and key. NOTE: All electronic lock units have been provided with an override key (skeleton key). Test your combination several times with the door open. (See back cover of this manual for your factory code.) B) Insert the four batteries as indicated. Remove key hook plate located on the inside back of the door by sliding the plate upward, then pulling toward you. ![]() A) Unlock door with the override key provided in the plastic bag attached to the owner’s manual, and open the door using the lever handle. Please note: This product is NOT designed to protect audio/video cassettes, floppy discs, data cartridges, film, photos or photo negatives.To install batteries, remove keypad by rotating the cover counterclockwise, then pulling toward you.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |